Firmware update chip for Pro-SOLO mk1
This product cannot be re-flashed. An EPROM chip must be replaced to upgrade the firmware.
firmware history - (replaced by mkII version March 2005)
||Added 2 new clock divide ratios. d2 gives 24 cpqn & d4
gives 48 cpqn to enable you to sync Linndrum
||Reset all controllers recognised
||All notes off recognised
||128 note range for CV, aux can now output
trigger signal for ARP2600
||Auto sync added, new wavetable for triangle LFO to sync
at top of wave instead of the middle
To check the firmware revision on the Pro-SOLO, hold both Inc & Dec
buttons in while you turn the unit on. The display will cycle round 4 groups of 2 numbers, so
K1CV4300.086 will be shown as 43 00 00 86.
BUY THIS UPDATE