Kenton Socket Upgrade Kits
Socket Upgrade Kit For:
PLEASE NOTE: Fitting a socket upgrade kit is a skilled job which should be undertaken only by a competent synth service engineer or fitted by us at our premises in South West London.
3 Socket Kit
Kit to add Hz/V / Gate / filter sockets to the Korg 770
When used in conjunction with one of our MIDI to CV converters, such as the Pro-Solo mkII, USB-Solo or Pro-2000 mkII, these three additional sockets will enable the synth to be played from a MIDI keyboard or MIDI sequencer.
The inputs are on 3.5mm mono jack sockets which provide the following control:
Hz/V - provides Hz/Volt control over the oscillator frequency
Gate - controls when notes play (0 volts = note off / >3 volts = note on)
Filter - controls the cutoff frequency of the low pass filter (from aux out of converter)
The kit contains all necessary components and diagrams for connecting the wires / components, and mounting the three 3.5mm mono jack sockets.
Used with a Pro-Solo mkII or Pro-2000 mkII this kit will give you the following control over the synth from a suitable MIDI keyboard or sequencer:
Notes - at least 5 octaves range - (this is not limited by the kit or converter, but by the synth itself)
Pitchbend - range can be set in the converter
Modulation - from converter's inbuilt LFO. Speed and waveshape can be changed in real time.
Portamento (slide) - rate can be changed in real time.
Filter cutoff frequency - can be controlled using any continuous MIDI controller (cc) or other MIDI message such as Aftertouch or Velocity
Low / High / Recent note priority - can be set in the converter
Single / Multiple note trigger modes - can be set in the converter
|Kenton PRO-SOLO MkII||Midi to CV Converter|
|Kenton PRO-2000 MkII||Midi to CV Converter|
|Kenton USB-SOLO MkII||Midi to CV Converter|