Retrofit Kit For:

Korg Monopoly

PLEASE NOTE: Fitting a Retrofit Kit is a skilled job which should be undertaken only by a competent synth service engineer or fitted by us at our premises in South London.

MIDI Retrifit Kit

• 

• This retrofit kit for the Korg Monopoly adds the following MIDI control:

  For incoming MIDI:
  Any MIDI channel can be selected
  Notes (MIDI note numbers ?? - ??) - transpose possible
  Pitchbend - (bends up and down - range as set by range control on synth)
  Mod Wheel
  Filter cutoff frequency (of low pass filter)
  
  By default:
  pitchbend is controlled by pitchbend messages
  mod wheel is controlled by Mod Wheel (CC#1) and also by Aftertouch messages
  filter cutoff is controlled by CC#16
  Sustain is controlled by Sustain (CC#64)

  however, any controller or aftertouch or velocity can be mapped to control other things so for example velocity could be mapped to control volume.

  For outgoing MIDI:
  No MIDI can be sent using this retrofit kit

  Hardware:
  MIDI In, & Thru sockets
  Push button (for programming the MIDI setup)
  Setups are stored in non-volatile memory (Eeprom)

  The kit comprises the following items:
  Circuit board - fits in the base of the Monopoly
  Small pack - contains DIN sockets and mounting hardware
  Large pack - contains cable assemblies
  User instructions - How to change from default settings and general instructions
  Fitting instructions - step by step fitting guide plus diagrams of where to connect what

  All kits are fully checked and tested before despatch

  Note: Our retrofit kits are not intended for installation by the end user. They should always be fitted by an experienced synth engineer.

  
  

Manual

Korg Monopoly Manual

Related Items

More information

What is MIDI to CV?

Solving MIDI Clock Problems

FAQ's

How to connect using our MIDI to CV Converters