Kenton MIDI Retrofit Kits
Retrofit Kit For:
YAMAHA CS-70M
PLEASE NOTE: Fitting a Retrofit Kit is a skilled job which should be undertaken only by a competent synth service engineer or fitted by us at our premises in South London.
MIDI Retrofit Kit
-
-
This retrofit kit for the Yamaha CS-70M adds the following MIDI control:
For incoming MIDI:
Any MIDI channel can be selected
Notes (MIDI note numbers 36 - 96) - transpose possible
Responds to program change (numbers 1 - 32)
Pitchbend - (bends up and down an 2 semitones)
Mod Wheel
Aftertouch
Filter cutoff frequency (of low pass filter)
Volume
Sustain on/off
Portamento on/off
By default:
Pitchbend is controlled by pitchbend messages
Mod wheel is controlled by Mod Wheel (CC#1)
Aftertouch is controlled by Aftertouch messages
Filter cutoff is controlled by CC#16
Volume is controlled by MIDI volume (CC#7)
Sustain is controlled by Sustain (CC#64)
Portamento is controlled by Portamento (CC#65)
However the above assignments can be re-mapped if required - so for
example velocity could be mapped to control volume.
MIDI Out: Not supported
Hardware:
MIDI In & Thru sockets
Push button (for programming the MIDI setup)
Setups are stored in non-volatile memory (Eeprom)
The kit comprises the following items:
Circuit board - fits on top of the metal processor box
Small pack - contains DIN sockets and mounting hardware
Large pack - contains cable assemblies
User instructions - How to change from default settings and general
instructions
Fitting instructions - step by step fitting guide plus diagrams of where
to connect what
All kits are fully checked and tested before despatch
Note: Our retrofit kits are not intended for installation by the end
user. They should always be fitted by an experienced synth engineer.
Related Items