| Kenton MIDI retrofit kit | |
| DCB port | |
| Use a Pro-DCB mk3 | |
| Pro-2000 (mk1 or mk2) | |
| You already have a Pro-4 | |
| Clock the arpeggiator | |
Kenton MIDI retrofit kit |
|
You can have the Juno-6 fitted with a Kenton MIDI retrofit kit. This offers the most comprehensive level of control. For incoming MIDI: For outgoing MIDI: Please see the retrofit info pages for more details about the retrofit kit. Click here for information about and to buy the Kenton MIDI Retrofit Kit |
|
DCB port |
|
You can control the Juno-6 externally if you fit your Juno with a DCB port. Click this link for the Kenton DCB port addition for the Juno-6 Once your Juno has a DCB port, the following options are open to you |
|
Use a Pro-DCB mk3 (Juno-6 requires DCB port fitted) |
|
| You can use a Pro-DCB mk3 (Juno-6 requires DCB port fitted - see above) DCB control does not offer quite as much control as the retrofit kit, it is in fact notes only as far as the DCB port itself is concerned. In addition, there is a VCF input on the Juno-6 which allows you to control the filter cutoff frequency. Link this to the Pro-DCB auxiliary output using a 3.5mm to 6.35mm jack cable to control the filter cutoff point. You can also modulate the filter using the MIDI-syncable LFO built into the Pro-DCB mk3, using the mod wheel. In addition, you can also link the clock input of the Juno-6 to the Clock output of the Pro-DCB mk3 again using a 3.5mm to 6.35mm jack cable. This will allow you to clock the arpeggiator in time with MIDI clock. You can vary the relationship between MIDI clock and the clock pulse going to the Juno-6 allowing you to clock 1/4 1/8 & 1/16th notes as well as triplets. Click here for the Pro-DCB mk3 (supplied with a DCB cable & power supply): |
|
Pro-2000 (mk1 or mk2) |
|
If you already have a Pro-2000 (mk1 or mk2), then you need only a the DCB port option added to your Pro-2000 (Juno-6 requires DCB port fitted - see above). Note that the DCB port for the Pro-2000 is OUT only, in other words you can play the synth using MIDI, but not the other way around. click here for the optional DCB port for the Pro-2000 (supplied with DCB cable): click here for 3.5mm to 6.35mm jack cables (1 or 2 if required): |
|
You already have a Pro-4 |
|
If you already have a Pro-4, then you need only cables (Juno-6 requires DCB port fitted - see above). The Pro-4 came equipped with a DCB port as standard (out only). click here for a DCB cable for the Pro-4: click here for 3.5mm to 6.35mm jack cables (1 or 2 if required): |
|
Clock the arpeggiator |
|
If you don't need to play the notes using MIDI, you can clock the arpeggiator using the Pro-SOLO mkII or a Pro-2000 or even a Pro-KADI, as they all have clock outputs. Again you will need a 3.5mm to 6.35mm jack cable. |
|